Pridėti į pageidavimų sąrašą

    EFR 1200CL-60W CO2 lazerio vamzdis

    Length=1200mm; Diameter=60mm

    Produkto kodas: PCLTE1200CL Kategorija:

    EFR 1200CL-60W  Glass Tube for CO2 Laser Engraving&Cutting Machine

    EFR 1200CL-60W laser tube is popular in laser marking/engraving industry with its stable performance, reliable quality and low failure rate.

    Life-time 3,000 hours 
    (= 1.5 years for shops working 8h/day and 5 days/week).
     Warranty  12 months
     Cooling Type  Water cooling ( Suggested chiller: S&A CW5000; Please use purified /distilled water)
     Working Environment  temperature 2-40℃; humidity 10-60%
     Working Current  Maximum 25mA.
    The running current must be kept below 22mA.



    Notes

    Do not clean the exterior surface of the output widow mirror with tools such as tampon; otherwise the output power will be seriously affected. The followings are the designated methods to clean up pollution in the exterior surface of window mirror.

    1) When the mirror is polluted, do not turn on the laser.
    2) Blow the mirror surface sideways with an air blower.
    3) Spray the pure alcohol on the mirror surface with sprayer.
    4) Turn on the laser after the alcohol gets fully volatilized.
    5) If the methods above don’t work effectively, it is necessary to go after the professional workers to use tampon with alcohol to clean the mirror surface from middle to edge. The best solution is to prevent the window from being polluted.  

    Quality Guarantee

    1. Within 180 days from ex-factory dated on the label, we guarantee free replacement if the rated power is less than 80% (testing must be under proper operation). The replacement will keep the same warranty policy(12months).
    2. From 6thmonth to the 12th month dated on the tube label, we provide free replacement if the rated power is less than 70%(testing must be under proper operation). The replacement will keep the same warranty policy(12months).
    3. The damage or problem caused by incorrect operation will not be covered by warranty policy.

    Attention

    It is forbidden to clean the mirror with acetone.
    The screw in the front and back ends of the laser tube is not allowed to be moved, otherwise the out power will be declined, even the laser will be scrapped.
    Put the acryl 300mm far away from output mirror, when testing the laser spot.

    Safety

    The laser beam is invisible light. Please wear protective glasses when debugging the laser. The positive pole is in high voltage. Pay attention to the security marks!

    Storage and Transportation Requirement

    Pour out cooling fluid in the event of storage and transportation, and cover the output terminal with a dust-proof plastic bag. The storage environment is 2-40℃, humidity is 10-60%. Pack the laser tube in its original way.

    Tubes operated in the wrong way is not under covered by warranty.