YONGLI A6s-130W CO2 Laser tube
Length=1650mm; Diameter=80mm
YONGLI A6s-130w Glass Tube for CO2 Laser Engraving&Cutting Machine
YONGLI Adopts patented technology to modify the beam size and quality effectively that solves the beam distortion, increase the effective power. Inner lens upgraded. Stable on longtime working, lifespan is longer.
| Life-time | 10,000 hours (= 4.8 years for shops working 8h/day and 5 days/week). |
|---|---|
| Warranty | 12 months |
| Cooling Type | Water cooling ( Suggested chiller: S&A CW5200; Please use purified /distilled water) |
| Working Environment | temperature 2-40℃; humidity 10-60% |
| Working Current | Maximum 30 mA. Recommend to keep under 24 mA. |
Do not clean the exterior surface of the output widow mirror with tools such as tampon; otherwise the output power will be seriously affected. The followings are the designated methods to clean up pollution in the exterior surface of window mirror.
1) When the mirror is polluted, do not turn on the laser.
2) Blow the mirror surface sideways with an air blower.
3) Spray the pure alcohol on the mirror surface with sprayer.
4) Turn on the laser after the alcohol gets fully volatilized.
5) If the methods above don’t work effectively, it is necessary to go after the professional workers to use tampon with alcohol to clean the mirror surface from middle to edge. The best solution is to prevent the window from being polluted.
- Within 180 days from ex-factory dated on the label, we guarantee free replacement if the rated power is less than 80% (testing must be under proper operation). The replacement will keep the same warranty policy(12months).
- From 6thmonth to the 12th month dated on the tube label, we provide free replacement if the rated power is less than 70%(testing must be under proper operation). The replacement will keep the same warranty policy(12months).
- The damage or problem caused by incorrect operation will not be covered by warranty policy.
It is forbidden to clean the mirror with acetone.
The screw in the front and back ends of the laser tube is not allowed to be moved, otherwise the out power will be declined, even the laser will be scrapped.
Put the acryl 300mm far away from output mirror, when testing the laser spot.
The laser beam is invisible light. Please wear protective glasses when debugging the laser. The positive pole is in high voltage. Pay attention to the security marks!
Storage and Transportation Requirement
Pour out cooling fluid in the event of storage and transportation, and cover the output terminal with a dust-proof plastic bag. The storage environment is 2-40℃, humidity is 10-60%. Pack the laser tube in its original way.
Tubes operated in the wrong way is not under covered by warranty.
Seotud tooted
CO2 lasertoru
CO2 lasertoru
Slovenščina